瓶盖的注射模设计（国外英文资料）.docVIP

瓶盖的注射模设计（国外英文资料） Injection molding of bottle caps Abstract: this paper introduces the application of bottle type in daily life and introduces the design process of the bottle cap. Key words: everyday product mould design practical die cad 1 introduction Commodities, without too much sometimes USES precision and strength of plastic gear, because the plastics has the plasticity strong, the density is small, higher than strength, affinity, high chemical stability, the characteristic of diversity of appearance, so popular with more and more manufacturers and the people. Plastic industry is an emerging industry, is along with the development of the petroleum industry but should be born, the plastic parts has already entered into almost all industrial departments and different areas of the Peoples Daily life. With mechanical industry electronics industry, aviation industry, instrument industry and supplies the development of industry, more and more demand for plastic molding parts, quality requirements also more and more high, this requires forming the development of the mould, the level of design and manufacture should be higher and higher. Analysis of plastic parts 2.1, ABS plastic ABS Chinese name: acrylonitrile-butadiene styrene copolymer Acrylinitrile-butadiene - Styrene. The basic features: Non-toxic and tasteless, microyellow, the molded parts have better luster, the density is between 1.02 ~ 1.05 g/cm3, the shrinkage rate is 0.3 ~ 0.8%. ABS is very wet, it needs to be dry before it is formed and requires less than 0.3 percent of water. Liquidity generally is about 0.04 mm in the clearance. ABS has excellent impact strength and does not decline rapidly at low temperatures. Good mechanical strength and certain abrasion resistance, cold resistance, oil resistance, water resistance, chemical stability and electrical properties. Molding characteristics: ABS has a higher viscosity when warming, so the molding pressure is higher. The resistance of pouring system to the m