智能照明系统的设计-自动化学院.docVIP

智能照明控制系统的设计 孟祥斌a，毛红艳a，王德君b (沈阳工程学院a.自动化学院；b.信息学院，辽宁 沈阳 110136) 摘 要: 本文以AT89S52为控制器，使用红外传感器以及光电传感器进行信号的采集，用单片机进行控制灯具的通断，设计一种教室智能照明控制系统并说明设计这种系统的方法。由现实的状况来得出需要设计一种能够节能的教室智能控制系统，然后介绍了教室智能控制系统的实现的总体设计，并从软件以及硬件两个角度分别介绍了本次设计的具体方法、步骤以及设备的调试情况。通过进行理论分析以及调试，这次设计所做的智能照明系统能够实现检测照度，检测室内是否有人，之后能够做出智能选择，能够达到我们最初要求的实现节能的目的，设计使用的器件均是实验室、市场常见的，使用简单，方便，并且价格适中的器件。这在另一种层面上也做到了一种节能。 关键词: 智能照明系统；单片机AT89S52；节能；智能控制； 中图法分类号: **** 文献标识码: A 文章编号 Design of intelligent lighting control system Xiangbin Menga, Hongyan Mao a ,Dejun Wangb (a. Department of Automatic Control Engineering, Shenyang institute of Engineering, Shenyang 110136, China ) (b. Department of Information Engineering, Shenyang Institute of Engineering, Shenyang110136, China ) Abstract: Based on AT89S52 as the controller, using infrared sensor and photoelectric sensor signal collection, using single-chip microcomputer to control the on-off of lamps and lanterns, design a classroom intelligent lighting control system and design method of this system. From reality to follow to design an energy-saving classroom intelligent control system, then introduces the overall design of the realization of intelligent control system of the classroom and respectively from the Angle of software and hardware two introduces the specific methods and steps of this design as well as the debugging of the equipment. Through theoretical analysis and debugging, the design for intelligent lighting system can realize the detection of illuminance, testing indoor if anyone, able to make smart choices, after can meet our original, the purpose of the implementation of energy-saving design using devices are common laboratory, market, using a simple, convenient, and affordable device. This is a kind of energy saving of different level. Keywords: Intelligent lighting system; MCU AT89S52; energy saving; Intelligent control 0 引言 照明发展到今天，已经不是一项简单地满足人类基本生活需要的基础，而是使人们生活品质更高的物质保障。特别是近几年，城市照明越来越受