78Q75.精轧前立辊压下量对轧件边部应力影响的研究-RAL喻海良.pdfVIP

2007 年全国塑性加工理论与新技术学术研讨会 2007 年 5 月 沈阳 * 精轧前立辊压下量对轧件边部应力影响的研究 1 1 1 1 2 喻海良 , 刘相华 , 陈礼清 , 李长生 ，时立军 (1.轧制技术及连轧自动化国家重点实验室(东北大学), 沈阳110004； 2.天津三星电子显示器有限公司，应用开发部，天津) 摘要: 采用有限元方法和几何更新方法对不锈钢粗轧过程变形行为进行模拟，得出精轧前轧件的截面尺寸，然后，采 用截面延伸的方法建立轧件模型，对其精轧立-平轧制过程变形行为进行了模拟，分析了精轧前立辊压下量对轧制过 程中轧件边部应力的影响。研究结果表明：当立轧压下量为 0-2 mm 之间时，随着压下量的增加，立轧过程中轧件角 部金属压应力显著增加，同时平轧过程中轧件承受拉应力时间减少；当立轧压下量为 2-5 mm 时，立轧过程轧件角部 金属承受压应力几乎没有变化，然而平轧结束后，随着立辊压下量的增加，轧件角部压应力减少。 关键词: 立轧压下量；裂纹；有限元 Research on Effect of Edge Roll Reduction on Plate-edge Stress before Finish Rolling YU Hailiang, LIU Xianghua, CHEN Liqing, LI Changsheng,Shi Lijiu （1.The State Key Laboratory of Rolling and Automation, Northeastern University, Shenyang 110004； 2. Tian jin Samsung electronics display Co.ltd R and D centre ） Abstract: Slab dimensions before finish rolling were obtained through analysis of the rough rolling processes of one kind of stainless steel by FEM and updated geometrical method, with which the FEM models of finish rolling process with edge roll was established, and influences of the reduction of edge roll on stress change regularity in slab edge was analyzed. Results showed: the reduction of edge rolling increased from 0 mm to 2 mm, the compressive stress in slab corner clearly increased in edge rolling, and the zone of tensile stress during whole rolling process decreased; the reduction of edge rolling increased from 2 mm to 5 mm, the compressive stress in slab corner seldom changed, and the compressive stress decreased after horizontal rolling. Key words: reduction of edge rolling；crack ；FEM 1 前言