山东省年高考历史二轮阶段检测精选预测卷含解析岳麓版必修.doc

2013年《山东高考》岳麓版历史必修一二轮阶段检测精选预测卷1（含解析） 一、选择题1．“两个魔鬼胜过一个圣人”是一句英国格言，典型地说明了民主宪政的特点。宪政就是让两个魔鬼友好地相处并相互制约，把恶作剧减少到最低的程度。这说明资产阶级代议制的关键和核心是 A．全体公民的参与程度 B．权力的制约与平衡 C．市民的整体素质 D．革命的彻底性2．3． ） A.两者的根本利益一致 B.美国法制健全 C.两党互相牵制 D.民主制度充分发展 4．5．6．7．8．9． A．古巴导弹危机结束 B．美苏关系趋于暖和 C．冷战格局全面终结 D．多极化世界的来临 10． ） A.秦朝的疆域 B.宋朝的疆域 C.元朝的疆域 D.明朝的疆域 11． A. 宗法制度下统治阶级内部政治等级尊卑有序 B. 用嫡长子继承制解决统治者的权力继承问题 C. 西周宗法制下女性不享有各阶层的继承权 D. 受封者在各自受封区域内享有土地所有权 12．13．( ) A.它为全体雅典人所享有，是古代世界上独一无二的做法 B.它是男性公民的民主，与古代世界上许多地方相似 C.它是奴隶制度下的民主政治，也有许多不足的地方 D.它与现代民主政治接近，不过是它的翻版而已 14．15．《汉书·刘辅传》中提到“中朝，内朝也。大司马左右前后将军、侍中、常侍、散骑、诸吏为中朝。丞相以下至六百石为外朝。”由此可见，中朝 A．创立于西汉B．长官亦为宰相 C．由皇帝亲信近臣构成D．参与政事的决策 二、非选择题 16．17． Ellipticity of elbow pipes with diameters less than or equal to 150 mm must be not greater than 8% diameter of 200 mm or less shall not be greater than 6%. Wall thickness of the pipe wall thinning rate must not exceed the original 15%. Crease roughness: diameter 125 mm or less, shall not exceed 3 mm diameter less than or equal to 200 mm, not more than 4 mm. 7.3.9 simmering bending production of square steel tube extension, to use the whole tube bending. Interface if necessary, the welding position should be located in the middle of the vertical arm. 7.3.10 install expansion joints should be done. If design is not required, pipe compensator lengthen should conform to the requirements in the following table: square scale length δ x is equal to 1/2. Pre stretch tolerance: casing + 5 mm, +10 mm. 7.3.11 pipe form, location, spacing shall meet the design and specifications. 7.3.12 piping on back or return pipe at higher levels of the upper to automatic valve to install a drain valve below the horizontal parts. 7.3.13 supports and hangers of checks and the number 1) hanger installed must be checked before installation of supports and hangers part models, specifications of springs setting values, whether the materials meet the requirements of drawings