SOLID65单位计算混凝土(国外英文资料).docVIP

SOLID65单元计算混凝土(国外英文资料) The SOLID65 unit calculates the concrete In the prestressed reinforced concrete structure, the steel bar is in the uniaxial stress state and the stress The strain relation is relatively simple. The steel bar is simulated by ANSYS, and the double fold line is adopted Constitutive relation and follow up hardening criterion (BKIN). In this paper, the bilinear constitutive model is used to strengthen the constitutive relationship of prestressed reinforcement The modulus of elasticity after yielding is 0.01 times of the original modulus of elasticity, BKIN; The prestressing tendons are subjected to stress-strain relations as shown in Fig. 1, and It is assumed that when the stress reaches the ultimate strength, the steel bar breaks. Fig. 1 stress-strain relation of prestressed tendon Fig11 Stress - stra in curve of preS2 Tressed steel bars Taking into account the obvious strengthening section after yielding of the prestressing tendon, yielding Modulus of elasticity E=0.05E. bone In analysis and calculation, double Linear kinematic hardening (BKIN) [5], the stress-strain curve of the steel bar is simplified Enter the double fold form and enter its elastic modulus and yield strength The SOLID65 unit of ANSYS is a unit for the development of heterogeneous materials, such as concrete and rock, which are much more compressive than tensile. It can simulate reinforcing bars in concrete, as well as cracking and crushing of materials. There are two special places to define SOLID65 units: 1. material attributes. Due to the complexity of concrete material, the strength criterion of concrete in a variety of ways to consider one to five parameters. Generally speaking, the more parameters of the strength criterion, the more accurate the description of the strength properties of concrete. SOLID65 uses the William-Warnke five parameter strength model, where the required material characteristics can be accomplished through the ANSYS material property definition dia