操作机使用说明(国外英文资料).docVIP

操作机使用说明(国外英文资料) 4. device description 4.1 overall overview The DDS track type forging machine is used for the operation of the upper forgings of the free forging press. The operating machine is a track type device, so it runs on the track. The clamp can rotate, vertically lift, tilt up and down, and move horizontally both at the front and back. The operating machine is driven by an electric motor through a hydraulic pump. All operations are driven by hydraulic pressure. Control commands for these operations are issued from the console. Electronic control allows remote manual operation and computer assisted operation. Press control (special accessories) and operation machine control integration, can be controlled by the process of forging. 4.2 technical data Track type forging manipulator SSM120 load Maximum load capacity 50KN Maximum load torque (relative to the end plane of the clamp bar) 150kNm Maximum tilt moment (related to front axle) 234kNm Load graph Drawing -Nr.432.765-1 Clamp size Clamping range of standard clamp Maximum jaw For round bars For square bars 1064 mm 865 mm Minimum jaw For round bars and square bars 150 mm Clamping range of disc clamp 0-1.650 mm Main dimensions Total length (clamp closure) 7908 mm Total width 4393 mm The total height on the ground is minimum / maximum 3377 mm Minimum horizontal forging position of clamp on floor 619 mm Vertical stroke of clamp 1203 mm The angle of inclination of the clamp 7.3 degrees The tilted angle of the clamp rod 11.5 degrees Left shift 175 mm Right shift 175 mm speed Jaw opening 5 seconds Jaw closure 7 seconds Clamp up 0-200 millimeters per second Clamp down 0-200 millimeters per second Clamp side shift 0-100 millimeters per second Clamp tilt 0-3 degrees per second Clamp down 0-3 degrees per second Clamp rotation speed 0-30rpm Forward / backward walking speed Transportation speed Forging speed 0-1.200 mm / sec 0-666 millimeters per second rate The main pump Speed of an electric motor Output rate Drive spee