样题(带答案)(国外英文资料).docVIP

样题(带答案)(国外英文资料) One, the judgment (total 40 minutes, each question 1 cent, correct painting square root x) In body repair operation, inert gas shielded welding operation is the most used. (a) The power line of the electric tools and equipment used when the body is repaired should be grounded properly. (fx) Use oxyacetylene welding operation for fuel tank. (a) The front wheel drive and rear wheel drive car are not the same. (a) The hallmark of a hardtop car is only one. (a) The longitudinal beam of the car has a special suppression in the manufacturing, increasing the degree of hardening of the area, and enlarging the strength of the longitudinal beam. (a) The frame of the X frame is narrow, rigid and good for bending deformation. (a) Todays small and medium cars are dominated by prefront drives, and the engine installation is based on horizontal. (fx) 9. After the station wagon because there is no single body, the greater the top inside of the rear panel and the lower rear window frame, will head the medial plate extends to the back plate and other measures to enhance the stiffness of car body. (fx) The front prodrome is identical to the front car of the vertical engine. (a) The surface precision of hot rolled steel is higher than cold rolled steel plate. (a) The beam of the door is not suitable for correction and should be replaced. (fx) The steel used in the car is low carbon steel and high carbon steel. (a) Precipitated hardened steel is a high-tensile strength steel which improves the strength of the steel by forming niobium deposits. (fx) Martensitic steel is a kind of double strength steel. (a) Heat treatment of steel is achieved by adjusting the heating temperature. (a) 17. Tempering process is used to increase the hardness, it is the hardening of material, again heated to 200 ℃, and then cooling of a heat treatment process. (a) The exhaust piping in the body is tin plate. (a) Aluminum alloy is good for corrosion because it is difficult to oxidize. (a) The de