- 12
- 0
- 约1.55万字
- 约 4页
- 2017-06-08 发布于浙江
- 举报
核电专用涂层应用分析_张耀
核电专用涂层应用分析
张耀
(苏州热工研究院,江苏苏州 215004 )
摘 要:介绍了核电站专用涂层性能要求和性能试验的相关标 岛和辅助系统统称为常规岛。与此对应,核电站涂料
准。分析了核电站专用涂层的技术现状和应用状况。概括了美 也可分为核电专用涂料和核电常规涂料。与核电设施
国核电专用涂料、秦山一期核电专用涂料和大亚湾核电专用涂
相对应的核电专用涂料和常规涂料如图 1 所示。核电
料主要类型。提出国内核电专用涂层的发展要求。
关键词:核电站;专用涂层;标准 常规涂料适用于核电站非辐射控制区,即除核安全设
中图分类号:TG174.461; TQ639 文献标识码:A 备内、外表面涂层以外的全部设备及构筑物,其技术
文章编号:1004 – 227X (2008) 07 – 0057 – 04 要求与其它工业领域同等环境条件下涂层的技术指标
Application analysis on special coatings applied to
一致,故不作为本文讨论的内容。
nuclear power plant // ZHANG Yao
Abstract: The performance requirements and relative
standards of performance test for special coatings applied to
nuclear power plant were introduced. The technology and
application status of special coatings for nuclear power plant
was analyzed. The primary types of special coatings applied
图 1 核电站专用涂层的分布
to nuclear power plant in US as well as Qinshan first stage
Figure 1 Distribution of nuclear power plant special coating
project and Daya Bay nuclear power plant in China were
summarized. The development requirements of special 2. 1 核电站专用涂层的分类
coatings for nuclear power plant in China were pointed out. 核电专用涂层是满足核电站所特有的环境条件、
Keywords: nuclear power plant; special coating; standard 技术要求的涂层体系。根据分布区域的不同,核电站
Author’s address: Suzhou Nuclear Power Research
专用涂料可分为 3 种类型:(1)安全壳内涂层即安全壳
Institute, Suzhou 215004, China
内全部设备及构筑物表面的涂层;(2)辐射控制区涂层
(不包含安全壳的辐射控制区内全部设备及构筑物表
1 前言
原创力文档

文档评论(0)