各车型轮胎气压复位(国外英语资料).doc

各车型轮胎气压复位(国外英语资料) 1: GM Buick tire pressure monitoring lamp When the tire inflation test system (TIMS) is in motion, the EBTCM monitors the speed of each wheel as compared with the speed (angular velocity) of other wheels, whether or not it exceeds the specified limit. If the pressure is low, the wheel speed will pass so fast that the system computer will monitor it. If the wheel speed difference monitored by the system computer exceeds a certain value, the tire pressure is considered to be too low. In this case, the EBTCM switches on the low tire pressure indicator light. But the tire inflation test system also requires several conditions. 1. system calibration (learning): the system will learn the pressure of each tire within the range of the vehicles speed. Usually it takes 45-90 minutes, three speeds (25-65 km / h, 65-105 km / h and 105 km / h) to complete the study. If the pressure of a tire differs from that of the other three tires, the 83kPa will warn you in 2-8 minutes. 2. guarantee the use of the original specifications of the tires. 3. reset in time. Reset system: switch the ignition to the RUN position, then press and hold the RESET (reset) button for about 5 seconds. The red reset button is located in the safe box on the dashboard, marked RESET. ) the tire pressure monitoring light will flash three times and then go out. Adjust the pressure or the lights to reset after each change of the tire, but never reset the tire when it is in trouble, otherwise the system will not work properly. 4. more than one tire pressure is low. The system cannot work. 5. vehicles running at speeds exceeding 95 km / h. The system cannot work 1: Shanghai Buick tire pressure monitoring system Tire pressure monitoring system reset When the tire pressure is too low (LOW TIRE) the warning light is on, the driver or technician should first check the pressure of the four tires and the specifications are correct. After completion of the corresponding maintenance, you can press the r