机、炉、电、化开停机过程中的工作安排(国外英语资料).docVIP

机、炉、电、化开停机过程中的工作安排(国外英语资料) Work arrangement in the process of machine, furnace, electricity and chemical shutdown Steam turbine operation First, the boot work arrangements: 1., the value of a long command issued to the ignition before the boiler: The turbine monitor should first check the unit work ticket has no effect on the end of the work; check the turbine in standby, oil quality, the oil level is normal; test the test manual on boot completed normal; lubricating oil and seal oil, EH oil, water, compressed air, cooling water, open and closed water, condensate water, water supply, auxiliary steam system start-up operation; the turning gear is in normal operation (hot start running less than 4 hours); vacuum was about -40kpa; the main parameters of the turbine before starting copy. 2. boiler before ignition to flushing before turning: The bypass system, drainage system and platoon system; small oil recovery system; water level plus side; confirm except low vacuum, machine jump outside the furnace all the remaining host protection were put in; check the turbine body and the metal temperature of steam pipeline pumping vacuum normal, maintain 60 ~ 80kpa. 3., before the turn, before the grid: Check turning and pump shaft automatic shutdown; low input and low cylinder steam side; automatic water input; start-up oil cooler water pump; valve switch and rated speed under normal brake; check the turbine vibration, axial displacement, differential expansion, expansion of the normal. 4. after grid connection: According to the rules of load, high investment, and the steam side steam pump, to conduct a comprehensive inspection of the turbine system; input machine jump furnace and low vacuum protection. Two 、 work arrangement before shutdown: 1. try to launch the AC and DC pump, low pump, pump shaft machine, turning motor no-load start, normal outage. 2., the auxiliary steam source is poured to the adjacent machine and the partition screen, and the valve control mode is cut to