第8章 电路仿真(国外英语资料).docVIP

第8章 电路仿真(国外英语资料) The eighth chapter circuit simulation.Txt This paper is contributed by dormitory Hao Ppt documents may experience poor browsing on the WAP side. It is recommended that you first select TXT, or download the source file to the local view. The eighth chapter circuit simulation chapter 8.1 basic concepts of circuit simulation Several basic concepts involved in simulation are as follows: (1) simulation components: components used by users in circuit simulation, requiring simulation attributes. (2) simulation circuit diagram: the user according to the specific circuit design requirements, the use of schematics, editors and components with simulation properties drawn by the circuit schematics. (3) simulation excitation: used to simulate signals in practical circuits. (4) simulation mode: there are many kinds of simulation methods, and different simulation methods correspond to different parameter settings. The user should select the simulation method according to the specific circuit requirements. (5) simulation results are given in the form of waveform. 8.2 basic steps of circuit simulation 1. edit simulation schematic diagram, drawing the schematic diagram, the components used in the diagram must have Simulation attributes. If an element does not have a simulation property, an error message 2. will be set up at the simulation, and the simulation excitation source is set. The simulation excitation source is the input signal, so that the circuit can start to work. The commonly used excitation sources include DC source, pulse source and sinusoidal signal source. 3. place the node network label and place the network label at the location of the circuit to be tested. 4. set the simulation mode and parameters, users should be based on specific circuit simulation requirements, set reasonable simulation methods and the corresponding parameters. Different simulation methods show different simulation results. 5. execute the simulation command, after the above sett