弯制卡环(国外英文资料).docVIP

弯制卡环(国外英文资料) Curved card ring One, the material and the instrument that bend the card ring (1) the material used for the bending of the brackets In stent production, card ring bending using various types of stainless steel wire. The connection body and teeth close bracket bending in addition to use steel wire after flattening, also have special finished steel. Stainless steel wire according to the diameter of the different and have different purposes, the classification of common dental stainless steel wire is as follows: Size 30, diameter. Below 25mm, the binding of orthodontia and orthodontia, 30-22, the diameter is 0.34 - o. 7mm. For various orthodontic lip bow and spring production Number 22, 0.7 mm in diameter - used for the bending of front teeth or gap CARDS. Number 21, 0.8 mm in diameter, is suitable for precursors ring, 20 diameter, 0.9 mm in diameter, is suitable for precurving and grinding ring 19, diameter 1.0 mm, suitable for bending the ring of grinding teeth, 18th, diameter 1.2 mm, press flat to be used for the bending of the teeth. In addition, there are also special curved pieces of flat steel for the bent teeth. (2) scaffolds make common equipment and USES The instruments used in curved brackets include the suns pliers, long nose pliers, small tongs, cutters, and so on. The side of the cross section of the pincers is round, and the side is crescent shaped, which is named after the lunar month, mainly for the curve of the curved card ring. The long nose pliers are used to bend the corners of the card ring, and the curved parts of the loop are fixed to avoid bending the other parts Completed part of the carring deformation. The three-headed tongs are also known as the tri-toothed tongs, which have three beaks at the end, which are the same as the pincers of the sun. The nose of the tongs is a nose, which is the same as the long nose pliers and is used to bend the Angle of the ring. Santoku pliers and three with forceps, pliers beak wide back, taperin