手机触屏飞线方法(国外英文资料).docVIP

手机触屏飞线方法(国外英文资料)A touch screen typically has four lines, usually 1.3 is a group, 2.4 is a group. The multimeter buzzer is measured in 400 and 600, and one group of them is the tube and the left and right side of the tube. Connection generally has the following several (right, bottom left, upper right, lower left) 1234 4123 2341 1432 3214 4123 if it is inside out you can according to the observation of the old and new at the bottom of the touch screen ribbon cable (if you look carefully at the bottom of the touch screen and the ribbon cable connection where you will discover something) to change the position. OK, so its OK to go up and down, you know, OK, OK, OK, so if you have a deviation, you can calibrate it, you cant calibrate it, and then you have to write software. Special care is that the line of the touch screen should not be too tightly folded in the front of the phones front casing or it will cause broken lines. If the touch screen and the limit box are too tight, remove the frame of the contact line. I hope you can help me.Analyses the principle of touch screen panel and ` substitution methodQUOTE:You can download to see, this is I see a good article on the website (I think) more and more in the past two years with a touch screen mobile phone, screen is bigger and bigger, in the new, some mobile phone screen bad can look for a new change, but there are a lot of recent out the card machine, no accessories can find, some machine to scrap, especially there is only the top layer the touchpad of touch screen is broken, the machine especially that of no buttons, threw a pity, for the high cost of the whole screen, sometimes I cant find the screen, is the most feasible way to change the touch screen is, according to the contrast test for a long time, finally mastered the method of separate replacement touch screen plate, in this give you.Now lets look at how the touch screen work, believe that most people know, but there are not too clear, there are many online i