数控车削复习题及答案(国外英文资料).docVIP

数控车削复习题及答案(国外英文资料) One, the question In the FUNAC system, the last line of the subroutine ends with the M30. (false) The point line control system not only controls the exact location from one point to another, but also controls the path from one point to another. (yeah) 3. The radius of circular arc interpolation with programming, when arc corresponding central Angle is greater than 180 °, radius of negative. (to) 4. CNC lathe using G54 - G59 instructions when programming, the program segment must be placed in the first paragraph, when performing the following program, otherwise will press machine tool coordinate system origin movement, which may cause a collision. (to) The positive direction of the part motion of nc machine tool is to increase the distance between the workpiece and the tool. (yeah) It is common to assume that the workpiece is moving in a stationary tool, regardless of the machine tool, when it is named or programmed. (yeah) Because of the difference in accuracy of the repeated positioning of the blank surface, the rough reference is generally used only once. (yeah) In the process of nc machine tools, the speed of the main shaft can be adjusted at any time, but it cannot be adjusted at any time. (wrong) 9. G50 instruction is to set the workpiece coordinate system by the program, and workpiece coordinate system is established, and the cutting tool knife related sites, and does not produce any move to do. (false) The program segment G41 G01 X10 Y40 D02 for the cutter radius compensation. G41 indicates the right compensation for the cutter radius. D02 indicates that the compensation number should be kept in the numerical control system for the number of the offset register. (false) In the G76 of multiple cycle instructions for threading, m indicates the final number of repetitions. (to) When the speed is related to the spindle speed, it is indicated that the quantity of mm/r is the default state of the nc lathe. (to) When the G00 instruction is quickl