气割技巧技能应用方法(国外英文资料).docVIP

气割技术技巧使用方法(国外英文资料)4.. The cutting nozzle is chosen according to the thickness of the steel plate, and the cutting oxygen streamline is checked by 4.2. The streamline should be straight and clear cylinder, if the streamline is irregular, close all valves to trim the mouth. The size of the flame should be adjusted according to the thickness of the workpiece. 4.4 when the gas cutting nozzle alignment cutting line heating workpiece to molten state at one end, drive fast wind make metal sufficient combustion, workpiece burn through before you start moving along the gas cutting line cutting nozzle. The cutting should start in the middle of the steel plate, such as the cutters, should be cut through the steel plate first, such as the thickness of the steel plate, and then the hole start to cut. 4.4.4.4.the mow is not perpendicular to the workpiece, it needs to be about 5 to 10 degrees centigrade, the flame rate is small, and the rate of gas cutting is fast. 4.4.4.74.the cutting mouth is perpendicular to the workpiece, the surface is 3-5mm from the surface, and the cut ends in the reverse direction of the cutting direction of 5-10 degrees, which is neat and neat at the end. Use the tug to cut the arc line, the cutting gun is not too high, especially the small arc thickness plate should make the cutting gun parallel to the workpiece. When working, the needle should be used for cutting the mouth, and the heat should be cooled in the water. The special steel of gas cutting is required by process. Remove the slag from the gas cutting and inspect the workpiece. How does the gas cutting preheat flame adjust the carbon flame neutral flame oxidation flame? Gas cutting work is to know the carbonizing flame neutral flame oxidizing flame right. Is the most basic common sense Simply say Carbide acetylene flame is to much. Gentle flame. And there is a bright white or blue flame. Oxygen oxidizing flame is to much. There is a white short flame Drive fast after the wind effect also is not