真空吸塑成型基本原理和术语(国外英文资料).docVIP

真空吸塑成型基本原理和术语(国外英文资料) In this paper, by blacklandzj contribution Doc documents may have a poor browsing experience at the WAP end. It is recommended that you choose TXT, or download the source file to the native view. Vacuum absorption molding principle and the term one, vacuum suction molding principle vacuum plastic forming process (figure 2-1) is a kind of hot forming process. Using thermoplastic sheet material, a method of making open mouth shell products. Heating softening plastic sheet cut into a certain size, with the help of a sheet on both sides pressure difference or mechanical stress, the deformation after stick on the specific mould contour, after cooling stereotypes, and trimming dressing. Vacuum moulding is formed by the ability of vacuum to stretch the sheet. Vacuum force is easy to achieve, master and control, so simple vacuum forming is the earliest and most widely used thermal forming method. Figure 2-1 basic schematic Second, no mould Vacuum without mould forming process as shown in figure 2-2, the sheet is heated to the required temperature, the clamping ring, with pressure ring clamp, open the vacuum pump valve, vacuum by photocell control valves to adjust vacuum, until the depth of sheet to the required shape. Because of the free vacuum forming method, the parts are not exposed to any molds surface, the surface of the making surface is high, without any defect. if The plastic itself is transparent, and the parts can have the minimum light absorption and transparency, so it can be used to make airplane parts such as instrument cover and skylight. In the process of molding, the vacuum moulding process can only change the degree of drawing and the shape of the outer profile, so it cant form the complicated parts. In addition, the forming process, with the increase of drawing, the maximum deformation area (that is, the thickness of the sheet) constantly decreases, and thus draw ratio in the process of production (H/D) should be less than 75% in gen