砖基础砌筑(国外英文资料).docVIP

砖基础砌筑(国外英文资料) Foundation brick masonry 1 scope This technological standard applies to the basic masonry construction of brick and exterior bricks of general industry and civil construction. Construction preparation Materials and main tools: 2.1.1 bricks: the variety of bricks, the strength grade must conform to the design requirement, and the specification is the same. There are factory certificate and test list. 2.1.2 cement: for Portland cement and Portland cement. 2.1.3 sand: medium sand, should pass 5mm aperture sieve. Make up the mortar with less than 10 percent of the mud. M5 and above mortar, sand is less than 5 percent of the mud, and it must not contain grass root and other debris. 2.1.4 mixing material; Stone plaster, powder coal ash and ground lime powder etc., the powder of lime powder should not be less than 7d. 2.1.5 other materials: drawing, burying, waterproof powder, etc. 2.1.6 main equipment: should be equipped with mortar mixer, shovels, froe drops, system board, wire, steel tape, brick, grey tank and a small bucket clip, string cable, sieve, brooms, eight clip on foot plate, steel and iron float, etc. 2.2 operating conditions: 2.2.1 base slot: the concrete or gray soil foundation is completed and the procedure is completed. 2.2.2 has already laid the basic axis and the border line; Set up the leather number rod (usually 15 ~ 20m, the corner should be set up), and complete the examination procedure. Then according to the number of skin stem bottom elevation of the bottom layer of brick, drawing check foundation pad surface elevation, such as brick horizontal mortar joint of the first layer is greater than 20 mm, should be with fine stone concrete leveling, it is strictly prohibited in the masonry mortar mixed with fine stone to replace or pad with mortar, more not allowed to cut down a brick zygote leveling. The clay bricks must be watered the day before the masonry, and it is advisable to dip the water into the four sides of the brick. 2.2.2.5 mo