针式打印机的基本结构和工作原理(国外英文资料).docVIP

针式打印机的基本结构和工作原理(国外英文资料) Basic structure and working principle of needle printer A printer, printer basic structure main job is to receive data, then according to the requirement of the host control command will print the information through the print head of print on the paper. The user can operate and use the printer through the control panel of the printer. The printer is divided into two parts: mechanical and electrical. Mechanical structure: printer mechanism consists mainly of printing head, transmission system, frame and shell. The printing head is used for printing in a car and is one of the key parts of the printer. The printer relies on the electronic circuitry to drive the printing of the steel needle impact ribbon, and the ink on the ribbon is attached to the paper to print out the information. The basic structure of the printing head includes the electromagnetic component, the printing component, the heat sink, the scaffold and the gasket. Print beard needle and armature are welded into one body, due to the role of the reset spring, armature in release state, thus from print wire ribbon in the stationary state. When a print head receipt printers print driving signal from the main circuit and the pulse current, the print head coil electricity, magnetic fields, make the core magnetization, attracting armature, so that the printing needle hit the ribbon, ribbon under the effect of print needle will print out a ink on the paper. Disappear when the pulse current, the print head loss of current coil, and lose the magnetic core, armature and under the action of the reset spring will print needle back, in a state of momentum. There is also a print head that USES energy storage. This type of printing head works by using a permanent magnet for the armature reed, which is stored in a storage state, where the printed needle holds the punch. Coil electricity, composed of iron core and coil of the electromagnet to establish a magnetic field, in contrast to the perman