SATA接口（国外英文资料）.doc

SATA接口（国外英文资料） The hard drive that dell has configured is SATA Is the full name of SATA Serial Advanced Technology Attachment (Serial Advanced Technology Attachment, based on industry standard Serial hardware driver interface), is by Intel, IBM, Dell, APT, Maxtor and Seagate company common hard disk interface specification is proposed. In 2001 by Intel, APT, Dell, IBM, Seagate, maxtor this several big manufacturers of Serial ATA committee formally established the Serial ATA 1.0 specification, in the IDF Fall conference, announced the Serial ATA standard 1.0, Seagate officially declared the establishment of the SATA specification. In 2002, while the Serial ATA device was not yet officially listed, the Serial ATA commission had first established the Serial ATA 2.0 specification. SATA specification will drive the external transmission rate has been increased to 150 MB/s, the theoretical value is 50% higher than standard ATA PATA / 100, about 13% higher than ATA / 133 also, and with the development of the future revision, the rate of SATA interface can also be extended to 2 x and 4 x (300 MB/s and the 600 MB/s). From its development plan, SATA will also increase the speed of the interface by increasing the clock frequency, allowing the hard disk to overspeed. SATA interface need the support of hardware chips, such as Intel ICH5 (R), VIA VT8237, nVIDIA MCP RAID and SiS964, if the occurrence of the mainboard chip cant directly support, you need to choose a third party chips, such as Silicon Image 3112 a chip, but it also can produce some differences in hardware performance, and the driver is multifarious also. The advantages of SATA: support for hot-plug, fast transfer, and high execution efficiency using a hard disk called Serial ATA, which is the trend of PC hard drives in the future. Serial ATA Serial connection mode, the Serial ATA bus USES embedded clock signal, has the stronger ability of error correction, compared with past its biggest difference is that can inspec