ibm服务器+RAID配置全程（国外英文资料）.doc

ibm服务器+RAID配置全程（国外英文资料） The IBM server RAID configuration is complete A, RAID is introduced The abbreviation of RAID is Redundent Array of Inexpensive Disks, literal translation for cheap redundant disk Array, also referred to as the disk Array. Then the letter I in RAID was changed to the Independent, and RAID became an Independent redundant array of disks, but this was only a change in the name, and the actual content did not change. Can put the RAID as a method of using the disk drive, it will be a set of disk drives in a logical way, as a logical disk drives to use. The advantages of the RAID Transmission rate is high. In part of the RAID mode, can make a lot of disk drives to transmit data at the same time, the disk drives on logic is a disk drive, so use RAID can achieve a single disk drives the rate at which a few times. Because the CPU is growing fast and the data transfer rate of disk drives cannot be significantly improved, there is a solution to the conflict between the two. Higher security. Compared with ordinary disk drives many RAID mode provides a variety of data repair, when a disk drives in RAID, severe fault cannot be used in other disk drive in the RAID to restore the data in the drive, and ordinary disk drive can not be achieved, the second reason is the use of RAID. The classification of the RAID RAID 0, no redundant, uncheckable disk arrays. Data distribution on each disk at the same time, there is no fault tolerance, read and write speed is the fastest in the RAID, but because any one disk damage can make the whole RAID system failure, so the safety coefficient but lower than a single disk. General use is not high for data security, but for high speed requirements, such as large game, graphic image editing, etc. This RAID mode requires at least two disks, while more disks provide more efficient data transfer. RAID 1, mirror image disk array. Each disk has a mirror disk, which is always consistent with the original disk. RAID1 has the highest s