I2C十六进制（国外英文资料）.doc

I2C十六进制（国外英文资料） The EEPROM module was debugged with AT24C64 The EEPROM module was debugged with AT24C64 AT24C64, A0, A1, A2, select the input, and then you can pick up 8 24C64 chips, SDA is a two-way data input outlet for the exchange of data between a memory and a single chip The SCL string clock type, the rise edge writes the data on the SDA to the memory, the drop edge reads the data from the memory to the SDA WP writes protect input, grounding allows write operations The IIC communication protocol is mostly in sequence So Im going to do the 24C64 EEPROM in IIC C51 program # I nclude reg52. H # I nclude intrins. H / / # define WDI P3_4 Pound sign define AT24c64_address 0xa0 / / A2, A1, A0, GND. The control byte of the EEPROM, in the form of (1) (0) (1) (0) (1) (A2) (A1) (A0) (R/W), where R/W = 1, / / read operation, R/W = 0 for writing operation, A2, A1, A0 for the page selection or selection of the EEPROM; # define uchar unsigned char # define uint unsigned int # define delayNOP (); _nop_ (); _nop_ (); _nop_ (); _nop_ (); # define NUM 10 Uchar idata sendbuf (NUM); Uchar idata receivebuf (NUM); Bit bdata SystemError; Sbit SDA = P0 ^ 0; Sbit SCL = P0 ^ 1; Uchar dat [9]. Void iic_start (); / / start the IIC bus Void iic_stop (); / / stop the IIC bus Void slave_ACK (); / / send a reply from the machine Void slave_NOACK (void); / / sending a non-reply from the machine Void check_ACK (void); / / host transponder check Void IICSendByte (uchar ch); / / send 1 byte Uchar IICReciveByte (void); / / receive 1 byte Void AT24c64_write_byte (uint address, uchar dat); / / 24 popular c64 memory 1 byte Uchar AT24c64_read_byte (uint address); / / read the 1BYTE data for the specified address Void AT24c64_read_bytes (uint address, uchar * pdat, uchar length); / / read the continuous data after the address Void AT24c64_write_bytes (uint address, uchar * pdat, uchar length); / / write a page of data to 24c64 Delay_tt_ms (uchar tt); / / delay TTMS / / / / / / / / / / / / / / / / /