车用化油器零件的注射模具设计毕业论文.docxVIP

车用化油器零件的注射模具设计  INCLUDEPICTURE /2003/photo/xiaohui.jpg \* MERGEFORMATINET  CHANGSHA UNIVERSITY OF SCIENCE TECHNOLOGY 毕业设计（论文） 题目： 车用化油器零件的注射模具设计 学生姓名： 学 号： 班 级: 材料成型1202 专 业： 材料成型及控制工程 指导教师： 2016 年 6 月  车用化油器零件的注射模具设计 摘要 注塑模具成型凭借其生产速度快、效率高，操作可实现自动化，形状可以由简到繁，尺寸可以由大到小的优点，在塑料模具设计领域有着重要的地位。注塑成型的过程是通过将塑料融化然后通过螺杆等推动下将融化的塑料挤进模具，然后充分冷却得到制品。 本次设计的塑料制品是车用化油器零件，是一种在实际应用的非常广泛的塑料制品。该制品形状复杂，且表面多凹槽，凹槽大多为上下对称结构。本产品使用的是PA66材料，在设计前期，利用三维软件建模并计算塑件质量，在应用模流分析确定浇口位置。在设计时，采用一个模具两个腔体的设计方案。对塑件结构形状进行实际分析，设计中要采用侧抽芯装置。在设计过程中，还要全面考虑到材料的性能对注塑机的选择、浇口的设计、模架的选择以及冷却水路的设计等。 关键词：车用化油器零件；注射模、侧抽芯 DESIGN OFREDWINEBOTTLEHANDLE INJECTION MOLD ABSTRACT Of injection molding with its production speed, high efficiency, can realize automatic operation, can shape by Jane to numerous, size can be from big to small, the advantages of an important role in the field of plastic mould design. Injection molding process is by putting a plastic melt and then through the screw will be pushed by the melted plastic into the mold, then cooled sufficiently to get products. The design of plastic products are automobile carburetor parts, is a kind of practical application is very wide range of plastic products. The product shape is complex, and the surface groove, groove mostly symmetrical structure. This product USES the PA66 material, in the early stage of the design, use 3 d software modeling and calculation of plastic parts, mold flow analysis to determine the gate location in the application. When the design, using a mold two cavity design. An analysis of the actual shape of plastic parts structure, will be adopted in the design of side core-pulling mechanism. In the design process, but also the comprehensive considering the performance of material choice of injection molding machine, the design of the gate, the selection of the die set, and the d