交叉指针案例（国外英文资料）.doc

交叉指针案例（国外英文资料）L p # I0.0 / / point ILAR1L W [AR1, p # 0.0]T MW100 / / sends the contents of the IW0 to MW100.The above program is a cross-section addressing, namely, access width [ARx, offset]. W [AR1, p # 0.0],W access width is a word and the offset is 0.0./ / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / /D [AR, P# 0.0] for which storage area in the CPU, you must also look at the previous statement.For example: 1, LAR1/2 P# M20.0 / / load address pointer P# M20.0 to AR1, AR2.L B [ar1/2, p # 10.0] / / B is the width, and the address is the address in ar1/2, M,The actual address is MB30.In your example, the address of D is the address of the address register AR, and D is the width of the data./ / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / /Load # POINTER_SOURCE / / mount # POINTER_SOURCE in the accumulator 1LAR1 / / load the contents of the accumulator 1 (ACCU1) into the address register AR1L W# 16 # 1002 / / load the 4098 decimal value into the accumulator 1 (ACCU1)T LW [AR1, P# 0.0] / / take the contents of the accumulator 1 (ACCU1) to the address register, AR1 + P# 0.0 (the address is two words)# SOURCE_DBNR / / load the # SOURCE_DBNR in the accumulator 1 (ACCU1)T LW [AR1, P# 4.0] / / take the contents of the accumulator 1 (ACCU1) to the address register, AR1 + P# 4.0 (the address is a double word)L # SOURCE_BEGIN / / get # SOURCE_BEGIN to the accumulator 1 (ACCU1)SLD 3 / / take # SOURCE_BEGIN times 8, and then save it in ACCU1OD DW# 16 #/ / the contents of the accumulator 1 (ACCU1) and DW# 16 #(decimal 2214592512), or operation, and then saved in the accumulator 1 (ACCU1)T LD (AR1, p # 6.0) / / will pass the contents of the accumulator 1 (ACCU1) to AR1 + P# 6.0L # SOURCE_LENGTH /