激光打印机常见卡纸故障及解决方法（国外英文资料）.docVIP

激光打印机常见卡纸故障及解决方法（国外英文资料） The laser printer is a common problem of card failure and solution 1) printer paper can not be put into paper or just in the printer. Its check program is: To check if the paper sensor is normal, and if it is not normal, the photoelectric sensor can be cleaned. (2) check whether rub the paper round electromagnetic clutch action, if not, then measure the electromagnetic clutch coil voltage is normal, if so, the repair replacement clutch, if not, check the clutch driving circuit; (3) check whether rub the paper round with paper powder, waste powder or aging such as sliding, if yes, can use alcohol to clean rub the paper round, or rubbing paper in fine sandpaper along the shaft to the sand rough, if not, can replace paper wheel rub; Check if the cardboard is done, and if not, repair the cardboard CAM. In general, the paper can be excluded from the paper. (2) the printing paper is in the passageway, the inspection procedure is: If the printing paper is distorted in the channel, if it is, the paper will be replaced. Check if the channel sensor is normal, if not, clean the photoelectric sensor induction window. Check to see if the paper wheel is slipping. If it is, the repair method is the same as the paper wheel. (3) the printer is in the fixing component. This is the part of the printer that the laser printer often has. Check if the channel photoelectric sensor lever is reset, if not, repair the resetting spring. Check to see if the guide board has the melted toner. If there is, the waste powder of the accumulated product is cleared. Check for the damage of the separation claw, or any of the waste powder contamination. Check to see if the photoelectric sensor is normal and if it is abnormal, clean the photoelectric sensor or the resetting spring. For the maintenance method of the above fault areas, it is generally possible to do the following maintenance. If printer setup correctly, when the carton paper, typed sensor shade lever is pushed chan