路由接口：DCE和DTE区别（国外英文资料）.docVIP

路由接口：DCE和DTE区别（国外英文资料） (1) what is a DCE? DCE: data communication device, DTE: data terminal device. 1) only on synchronous communication lines will have the clock rate, when the synchronous communication need to be done on both ends of the line signal frequency synchronization, namely synchronous clock, in the practical engineering by the protocol converter, such as modem line control equipment to provide, but there is no specific line control equipment in the experimental environment, so that by a router serial interface to provide. The determination of the DCE end is determined by the sequence of cable between the router, so the back to back cable indicates DCE and DTE. 2) the clock rate is required only for the DCE end There is no direct link between the frequency of the synchronous clock and the bandwidth of the clock, and the 64000 is the 64000 bit time interval that adds the sending synchronization bit 4) you can set other values, so long as both ends meet that standard, there is no effect on communication What is the difference between DCE and DTE? The distinction between DTE and DCE is only for serial ports, and routers usually connect to the wide domain network via serial ports. Serial v. 24 port (25 needles) usually DTE by 2 root stitching as TXD (sending data line), 3 root pins for RXD (receive data line), (the rest of the stitch is: 7 is a signal ground, 4 is the DTS, 5 is RTS, 6 is DTR, 8 is DCD, or send the clock, including receiving clock and so on, all have stipulated specific pins), serial v. 35 (34) needle is router usually adopted communication interface standard, but v. 35 is to use the differential signal transmission, sent and received by two signal lines respectively. The DCE device is usually docked with a router, so the distribution of the pins is the opposite, which is to receive (but also called TXD), and three to send. So routers are usually DTE devices, the modems, GV converters, and so on are usually defined as DCE. Actually for a sta