避雷接地小知识（国外英文资料）.docVIP

避雷接地小知识（国外英文资料） 1, the grounding The ground electrode is made of 2-688 ~ 2-695, which can be divided into steel pipe ground pole, ground pole, round steel ground pole and ground plate (block). Description: ground is ground body, is buried in the ground and direct contact with the earth for the metal conductor. The ground electrode length is calculated according to the length of the design, the design is not specified, each length is calculated by 2.5 meters, if the design has a tube cap, the pipe cap is calculated by the addition of the work. Ground is commonly used in small buildings, and there are no piles of engineering. 2, grounding bus bar Ground bus is laid: the norm is 2-696 ~ 2-700, which can be divided into indoor ground bus laying, outdoor ground bus laying, copper grounding stranded wire Description: 2.2 grounding bus bar is all grounding line remit together after the grounding line, generally adopts flat iron or round steel, outdoor grounding bus bar installation in a ditch, trenching, according to design requirements before laying groove depth shall not be less than 0.5 meters, then sat on a flat iron. The ground bus does not do the diffuser, the ground bus and ground body and ground feeder are usually welded. Outdoor grounding bus bar groove width of trench according to 0.4 meters, 0.5 meters wide on the deep 0.75 meters, per metre groove earth volume is 0.34 cubic, design requirements such as buried depth is not at the same time, can be adjusted according to the different quantity. 2.3 grounding bus bar when calculating quantities should be designed according to the drawing of vertical and horizontal length length and * 1.039, computing time consuming material should be according to the market price * attrition rate accordingly. 3, ground jumper The ground wire is installed: the norm is 2-701 ~ 2-703, which can be divided into ground wire, frame ground and steel aluminum window grounding Description: 3.2 grounded jumper, lightning protection grounding