湿热地区毛细管地板供冷末端性能实测探析.doc

湿热地区毛细管地板供冷末端性能实测探析 　　摘要：选取重庆某住宅卧室进行实测分析，在供水温度为20、18、16 ℃，室外天气为晴天、多云、阴天（雨）工况下，研究毛细管地板供冷房?g温度、地板供冷量、地板结露特征。供水温度为20、18、16 ℃时，室内最高温度27.6 ℃，最大供冷量分别为23、33、32 W/m2。开始结露时间为10：30―14：50之间，其中80%区域开始结露的时段为11：00―13：00之间，室内气流涡旋区最早出现结露。供水温度为18 ℃时，除湿能明显改变地板结露现象；供水温度为16 ℃时，除湿能改变大部分地板结露现象，室内气流涡旋区仍为结露区，但结露时间延后1 h以上。地板结露区域与室内气流组织有关，毛细管铺设位置应避开房间气流漩涡区 关键词：湿热地区；毛细管；地板供冷；室内温度；供冷量；结露 中图分类号：TU831.3文献标志码：A文章编号2017 收稿日期 基金项目：国家重点研发计划项目（2016YFC0700301、2016YFC0700303） 作者简介：刘猛（1979），男，教授，博士生导师，主要从事绿色建筑技术、建筑节能研究，（Email）liumeng2033@126.com Received Foundation item：China National Key R D Program （No.2016YFC0700301， 2016YFC0700303） Author brief：Liu Meng（1979）， professor， doctoral supervisor， main research interests： green building and energy efficiency， （Email） liumeng2033@126.com.Experimental analysis of terminal performance for floor cooling with capillary tubes in hothumid area Liu Meng， Wang Xudi （Key Laboratory of the Three Gorges Reservoir Regions EcoEnvironment， Ministry of Education； National Centre for International Research of Lowcarbon and Green Buildings，Ministry of Science Technology， Chongqing University， Chongqing 400045， P. R. China） Abstract：Indoor temperature， cooling capacity and condensation characteristic of capillary tubes for floor cooling were specially investigated with 20 ℃，18 ℃，16 ℃ inlet water temperature. Experiment was carried out in a bedroom in Chongqing in sunny， cloudy and overcast weather condition. The results showed that the highest indoor temperature was 27.6 ℃， the maximum cooling capacity were 23 W/m2，33 W/m2，32 W/m2 respectively. Adverse condition of condensation was happened between 10：30 to 14：50， among which 80% area started condense from 11：00 to 13：00. Indoor air eddy area was very easy to be condensed. The dehumidifier could reduce condensation dramatically with 18 ℃ inlet water， but eddy area was still condensed with 16 ℃ inlet water， The condensation area was related to ind