汽车专业英语：第十六章.ppt

Fig16-18 Cut the ribs 返回 Fig16-19 Grind off the edges of the roof cuts 返回 Fig16-20 Apply the protective foil strips 返回 Fig16-21 Place the wind deflector in the holes 返回 Fig16-22 Attach the wind deflector 返回 Fig16-23 Drop the sunroof into the cutout 返回 Fig16-24 Remove the “A” pillar cap 返回 Fig16-25 Remove the two retaining screws 返回 Fig16-26 The motor can be sild 返回 Fig16-27 Put the motor fastening screws in 返回 Fig16-28 Push the frame sides on 返回 Fig16-29 Place the supports in position 返回 Fig16-30 Connect the operating switch 返回 Fig16-31 Fit the front trim cover 返回 Fig16-32 Guide the wire for the operating switch 返回 Fig16-33 Fit the rear trim cover 返回 Fig16-34 Fit the side trim cover 返回 Fig16-35 Trim the excess with wire cutting pliers 返回 Fig16-36 The finished installation 返回 Unit16 How to Accessorize a Ride 16.1 How to Install a Sunroof 16.2 Replacing Old Carpet 16.1 How to Install a Sunroof Just about everyone dreams of driving down scenic roads with the wind in their hair. Of course, this dream isnt always attainable or very practical, but theres always the option to install a sunroof for the next best thing to a true convertible (Figure 16-1, Figure 16-2). The sunroof comes complete with everything that youll need (except tools) to make quick work of the installation. Before beginning, check the completeness of the sunroof package using the provided parts list (Figure 16-3). 下一页 返回 Then, locate, mark and tape the proper position for the roof cutout template (Figure 16-4). Position the template flat against the roof and tape it making sure it’s straight and there are no creases (Figure 16-5). Using a single-edge blade, carefully cut out the area of the paper template for the roof cut and draw the cut outline on the roof metal with a marking pen (Figure 16-6). 返回 上一页 下一页 16.1 How to Install a Sunroof 返回 下一页 上一页 Drill the six holes as marked on the front of the template for the wind deflector, making sure not to damage the inside roof lining. A “bit stop” can b