常用的塑胶原料的特性(国外英文资料).doc

常用的塑胶原料的特性(国外英文资料) The characteristics of commonly used plastic raw materials,.Txt life, are used to operate, rather than used to care about. Love is used to hold, not to test. Love is for love, not for hurt. Money is for enjoyment, not for measure. Lies are used to break, not to decorate. Trust is for precipitation, not for challenge. Chapter 1 understanding of plastic raw materials, injection molding process I. understanding of common plastic raw materials * PE material: scientific name polyethylene, divided into low density, high density two kinds. Low density is a combination of high pressure, high density is under low pressure combined, low pressure PE similar to PP material, high pressure PE is soft, close to 60%PVC. The main number of low pressure products is 606, and the main products of high pressure are 248 and 208. PE material and PP material can be mixed, but the liquidity is not good. * PP material: scientific name polypropylene is the most common, most widely used plastic material, the company commonly used product number is blessed, poly 366 and PP7533, durability, good impact, PJ3001V2 for fire grade materials. * close to the properties of ABS and AS, but its flow performance is not the same, AS is relatively fragile, ABS707 economic type, 757 for high rigidity high gloss, 765BVO is fire prevention, the main performance of ABS for water absorption, chemical resistance, so must be dried before molding, in addition to its poor liquidity, to the high temperature and pressure, burning smell. * PS material is hard glue, but because it is more brittle, not in line with the provisions of safety regulations, so now less use, impact resistance, PS475 burning when emitting a flavor, HIPS is impact resistant plastic, mainly used in the manufacture of toys and so on. * PC material name polycarbonate, characterized by excellent engineering plastic, high impact strength, high light transmittance, light transmission rate can reach 90%~95%. * PA material name nylon,