常见的器件封装(国外英文资料).doc

常见的器件封装(国外英文资料) Electrical, graphic, symbolic, and encapsulated forms of Protel99 common components: 1. standard resistance: RES1, RES2; package: AXIAL-0.3 to AXIAL-1.0 Two port variable resistance: RES3, RES4; package: AXIAL-0.3 to AXIAL-1.0 Three port variable resistance: RESISTOR, TAPPED, POT1, POT2; package: VR1-VR5 2. capacitors: CAP (non-polar capacitor), ELECTRO1 or ELECTRO2 (polar capacitor), variable capacitor CAPVAR Package: non polarity capacitor from RAD-0.1 to RAD-0.4, with polarity capacitance of RB.2/.4 to RB.5/1.0. 3. diode: DIODE (common diode), DIODE SCHOTTKY (Schottky diode), DUIDE TUNNEL (tunnel diode), DIODE VARCTOR (varactor diode), ZENER1~3 (zener diode) Package: DIODE0.4 and DIODE 0.7; (as mentioned above, remember to make PCB, dont forget to encapsulate the port of DIODE instead of A, K) 4. transistor: NPN, NPN1 and PNP, PNP1; pin package: TO18, TO92A (ordinary triode), TO220H (high-power transistor), TO3 (high-power Darlington tube) The above package is triangular. T0-226 is a straight line, and we usually use 9013 and 9014 pins in line type, so we use TO-126 in general transistors! 5, effect tube: JFETN (N channel junction type FET), JFETP (P channel junction type FET), MOSFETN (N channel enhancement mode), MOSFETP (P channel enhancement tube) The pin package is the same as the triode. 6, inductance: INDUCTOR, INDUCTOR1, INDUCTOR2 (ordinary inductance), INDUCTOR, VAR, INDUCTOR3, INDUCTOR4 (variable inductance) 8. rectifier bridge schematic commonly used in the name of BRIDGE1 and BRIDGE2, pin packaging for the D series, such as D-44, D-37, D-46 and so on. 9. single row multi pin socket schematic diagram commonly used in the name of CON series, from CON1 to CON60, pin packaging form for SIP series, from SIP-2 to SIP-20. 10. dual in line component schematic commonly used in accordance with the name of the different functions, pin package DIP series, Not as good as 40 pin single-chip microcomputer package for DIP40. 11. series parallel port