快速使用CAD(国外英文资料).docVIP

快速使用CAD(国外英文资料) CAD graphical import software after the identification of the detailed steps are: first, import CAD map: 1, click the navigation bar CAD identified under the CAD sketch. 2, click the import CAD diagram button, in the import CAD graphical dialog box, select the CAD diagram to import, such as select the 02 canteen structure, the right side appears to import graphics. This graph can be enlarged. 3, appear in the following file name column: XX structure, click open. 4, when the enter the original ratio dialog box, the software is set to 1:1, click OK. In this way, the CAD diagram of the XX structure is introduced. Two, save the CAD figure: sometimes, there CAD a plurality of floors, a variety of component types together a project, in order to facilitate the map, the need to separate each floor split out, then we must separate one by one floor plan to use the export as a separate file, and then use the file identification. Method: 1. Click CAD identification in the menu bar, and then click export selected CAD graphics. Then, in the drawing area, pull the box to select the diagram you want to export. 2, click right-click to confirm the pop-up save as dialog box. 3, in the Save As dialog box in the file name box, enter the file name as the pile base, click the save 4, in the pop-up prompt dialog box, click OK to complete the export preservation split CAD map of the operation. Three, clear the CAD diagram: after all drawings are exported and saved, click the clear CAD diagram button, then you can clean all the original CAD map. Four, extract the split CAD diagram: 1, first switch to the basic layer, click Import CAD diagram, pop-up the import CAD graphics dialog box. 2, select the base diagram, click open, in the pop-up, please enter the original scale dialog box, the software is set to 1:1, click ok. So the base diagram shows up. Five, shaft network identification: 1, click on the navigation strip under CAD identification, click identification axis network.