汽车工艺(国外英文资料).docVIP

汽车工艺(国外英文资料) Auto assembly and debugging process A, judgment, Accelerate the arrangement of drawing, the direction should be smooth, can be forced bending or fixed phenomenon The radiator pipe, the water pipe should not be deflated, the water pipe should not leak the square root The maximum load quality of the car is the maximum quality of the shipment When the car is moving, the petrol engine comes in with the mixture of petrol and air, and the diesel engine comes in the square root of the air 5, drive train, the engine output power to drive the wheels, and adapt to the need of driving conditions, change the size of the torque, to ensure the normal operation of the car) The fuel line should not be tied up with electrical bundles. Square root 7, you can use a pneumatic wrench instead of tightening by using a pneumatic wrench Before adding the brake fluid, take a vacuum square root The pre-beam values are measured and cannot be adjusted only by x When the bolt is assembled, just keep it tight, no matter which tool you take Average fuel consumption refers to the fuel consumption of a car on a road when it is empty In the tyre specification, the letter D indicates the diameter of the tire, and B indicates the thickness of the tire The five engines of the engine are the fuel system, the lubrication system, the cooling system, the start-up system, the transmission system (the petrol engine special) The seat belt is used to control the movement of the crew through high-intensity weaving, reducing or avoiding collisions with other objects by the square root In car assembly, fuel oil and coolant are the auxiliary materials The first phase of the construction of the factory is the feasibility study The general assembly plants of the automobile include: the whole vehicle assembly, the inspection, the rerepair, the trial road and the square root The design of the soil in the factory mainly consists of two large square root of the design and design of the building The total ass