质检员(国外英文资料).docVIP

质检员(国外英文资料) Calculation problem 1. a project with concrete laboratory is 1:2.2:4.26, water cement ratio is 0.6, the amount of cement per cubic meter of concrete is 300kg, the measured field sand moisture content is 3%, the stone water rate was 1%, with 250 liters (except material capacity) stirrer. The mass ratio of 1m3 is 1:2.2:4.26:0.6 Because the cement content per cubic meter of concrete is 300kg So the quality of each substance in 1m3 is: 300:660:1278:180 There because 250 litres =0.25m3 So the quality of each substance in 0.25m3 is: 75:165:319:45 1 、 the construction mix ratio of this project is (C). A, 1:2.2:4.26, B, 1:2.23:4.27, C, 1:2.27:4.3, D, 1:2.3:4.26 Water content = dry mass of water / substance Sand: 2.2* (1+3%) =2.27 2.2*300* (1+3%) /300=2.27 Stone: 4.26* (1+1%) =4.3 4.26*300* (1+1%) /300=2.27 2, the amount of cement for each mixing is (D). A, 300kg, B, 200kg, C, 100kg, D, 75kg 3, the amount of sand for each mixing is (A). A, 170.0kg, B, 165.0kg, C, 600.0kg, D, 681.0kg 4, the amount of stone for each mixing is (A). A, 322.7kg, B, 319.5kg, C, 1278.0kg, D, 1290.0kg 5, the amount of water for each mixing is (C). A, 45kg, B, 36kg, C, 36.9kg, D, 40.1kg 2. a diameter of 16mm steel bar, tensile, measured to yield when the load is 72.5kN, the maximum load can be 108kN. The gauge distance of the specimen is 80mm, and the length after breaking is 96mm. Area of reinforcement = =3.1415926 * () 2 =201.1 Strength formula = = (* 1000 unit conversions) 1, the yield point of the steel bar is (B) Mpa. A, 375 B, 360 C, 420 D, 350 The yield strength (i.e. yield point) = = x 1000=360.6 (revision 360) 2. The tensile strength of this steel bar is (C) Mpa. A, 555 B, 530 C, 535 D, 640 The tensile strength of 1000=537.1 (x = = revision 535) 3, the elongation of the reinforcement is (A)%. A, 20 B, 20.6 C, 32.5 D, 12.8 Elongation = 4, the reinforcement ratio is reasonable? (A) A, reasonable B and unreasonable; Yield strength = 5, bending strength than small steel, the use of r