压力管道2007(国外英语资料).docVIP

压力管道2007(国外英文资料) And In 2007, the pressure piping designers checked the papers Name: unit: achievement: I. judgment questions (1 points per subject, 20 points each) 1., the production area of petrochemical enterprises should be located in the neighboring towns or residential areas, with the smallest annual The leeward side of the frequency wind. (3.1.2 GB50160.P4) (x) 2., in the same building, should focus on the room in the fire, less dangerous One end. (4.2.18 GB50160.P15) (V) 3. equipment, buildings and structures shall be in accordance with the characteristics of the production process and fire hazards Do not partition the layout. The training materials of P123.5.1.10- (7) (V) 4. air cooler shall not be arranged at operation temperature equal to or higher than material spontaneous ignition point and conveying, Storage of liquefied hydrocarbon equipment above; otherwise, non combustible material shall be used for isolating protection. Pei P128.5.1.21- training materials (3), (V) 5. when the total volume of the full pressure liquefied hydrocarbon tank is larger than 10000m3, the tank group shall be provided with a partition The dike embankment, the total volume of the tank and should not be greater than 10000m3. Capacity of a single tank is greater than 5000m3, should be separated from each. (GB50160.P30 article 5.32. Three) - (x) 6. the piping shall be as possible as possible for piping of solid material or containing solid material Short, less turning and no dead ends. P172.5.2.5- training materials (15) - (V) 7. the pipe fire arrester on the fuel gas pipe of the heating furnace shall be close to the heating furnace and be convenient The distance between the pipe fire arrester and the burner shall not be less than 12m. SH3012 P13.5.2.1 (x) 8. the steam branch shall be removed from the top of the steam head, and the shut-off valve on the branch shall be as far as possible Fit close to the main pipe to avoid liquid storage. SH3012 3.7.1.1 (x) 9. flammable gas