焦化技术问答- 除焦(国外英语资料).docVIP

焦化技术问答- 除焦(国外英文资料) Coke removal system High-pressure water pump What are the parts of the high-pressure pump set? Answer: high pressure water pump group includes: high pressure water pump, speed increasing box (gear box), high voltage motor What are the performance parameters of high pressure pumps? Answer: flow 250m3/h, minimum flow 110m3/h, head 2880m, shaft power 2737kw, speed 3780rpm, efficiency 71.5%, cavitation margin 9.4 M. Whats the model of high pressure water pump? What is the impeller series? Answer: model TDQG250 - 290 x 10, impeller series is 10. What are the flushing methods and mediums of high pressure water pump mechanical seals? What is the pressure and flow rate? Answer: mechanical seal washing way for external flushing, flushing medium for softening water, pressure 0.2~0.3Mpa, water volume is 2.2~2.7 m3/h. What is the speed difference between the gear box low speed shaft and the high speed shaft? Answer: low speed shaft speed is 1492 rpm, high speed shaft speed is 3780 rpm. What is the type, rated voltage and rated power of high voltage water pump? Answer: motor model is YKS710-4 4, rated voltage of 6000 V, rated power of 3300 kw. What kind of cooling method is used for high pressure water pump motors? Answer: full closed water - wind cooling. What are the conditions for starting high pressure pumps? Answer: 1) the main cabinet is connected to the power supply. 2), barring examination noabnormalities to seal washing water and motor cooling water. 3) the lubricating oil system runs normally, and the oil pressure and the flow rate are normal at each injection point. 4) high water tank level is normal. 5) and the coke control valve is in the reflux state. 6) complete the tower selection. 7) pump allows starting to confirm. What are the interlocking stops for high pressure pumps? Answer: 1) pump suction, low pressure, trip, interlock (stop). 2) high level water tank low trip, interlocking (stop). 3) low lubricating oil pressure, delay 0.5 seconds, int