现浇箱梁(国外英语资料).docVIP

现浇箱梁(国外英文资料) Construction scheme of cast in place continuous section box girder 1. Design brief The upper structure of the bridge is the 4 hole of a (4 * 25m) of cast-in-place prestressed concrete box girder beam, high 1.40M, high 1.0m chamber, bridge length 100m, width 15.0m bridge, about double, single wide beam 7.5m, which Dikuan 3.75m. The bridge and the main line of a plane orthogonal, mostly in the line segment, gentle curve segment after a small part in A=60 and R=60m, located in the longitudinal slope of + 3.8%, - 2.4%, R=2000m vertical curve radius of vertical curve, its two-way cross slope 2% deck transverse slope to spin box girder instead. The abutment adopts single double GPZ3DX basin support, pier No. 2 is consolidated by piers and beams, and single and single GPZ6DX basin supports for Pier No. 1 and 3 are used. The geological conditions under the bridge are 4m thick sub clay, 5m thick, cohesive soil, gravel, siltstone and so on. 2, construction plan overview (1) support foundation; On the construction of the bridge can be cleaned, leveling, cleaning slag backfill 1m, compacted, and then under the siltstone slag filling to the beam at 1m, when filling the layered paving, layer thickness is 40cm, when filling burying settlement of pile settlement observation, observation once every three days, until the filling one month after the completion of three consecutive times, and the settlement does not exceed 3mm, then uninstall 1m, leveling, compaction, testing requirements and finally laying 10cm thick gravel, pouring 10cm thick C20 concrete as foundation support. See Figure 1 for details. (2) erection of bracket; According to the design plan, full support cast-in-place construction, the construction of the left and right width before and after. At the completion of support foundation construction, setting out of box girder, determining the plane position, in the set up at a predetermined position, the vertical plane steel pipe vertical and horizontal spaci