【2017年整理】家电外饰件表面检验要求.docVIP

注塑外饰件表面控制要求Injection control requirements for exterior surface 外观 Appearance 具体见附表 See the attached table of detailed defects. 色差控制 Color control 制件表面色差控制：颜色按封样色板，Δ≤0.7（D65光源）。 Color control: the color refer to standard sample Δ≤0.7（D65 light source）Painting control 制件喷涂：a.喷涂均匀完整、不粗糙、无暗纹、亮斑，不能有局部堆积，少油、纤维丝；b.喷涂牢固，硬度符合要求。喷涂层色差光泽均匀、光亮；c.附着力用百格刀划格，用胶带迅速拉，不露底为合格 Components painting:: a. painting complete, not rough, no dark grain, and light spot, cannot have the partial stack, few oils, and fiber. b. painting is reliable, degree of hardness meets the requirement. The painting is luminous; c. pull