1 手机EMC测试与设计介绍-20120613.ppt

4.3.手机EMC设计常用器件：TVS 各种接口。 注意TVS的结电容，高速信号选择较低的结电容。 不是最理性的选择. 4.4.手机EMC设计常用器件：压敏电阻 4.4.手机EMC设计常用器件：压敏电阻 4.4.手机EMC设计常用器件：压敏电阻 压敏电阻 TVS二极管 价格 便宜 较高 防护效果 一般 很好 4.5.手机EMC设计常用器件：EMI filter 4.5.手机EMC设计常用器件：EMI filter 4.5.手机EMC设计常用器件：EMI filter CPU EMI filter IP4254CZ12-6 T-flash Card Clock Clock Wrong PN. IP4252 is right. 4.5.手机EMC设计常用器件：EMI filter 防止 4.5.手机EMC设计常用器件：EMI filter 防止 4.6.手机EMC设计常用器件：共模扼流圈 4.6.手机EMC设计常用器件：共模扼流圈 共模扼流圈中的负载电流产生的磁场相互抵销，因此磁芯不会饱和。 4.6.手机EMC设计常用器件：共模扼流圈 EMC工程师必须具备以下八大技能 1、EMC的基本测试项目以及测试过程掌握； 2、产品对应EMC的标准掌握； 3、产品的EMC整改定位思路掌握； 4、产品的各种认证流程掌握； 5、产品的硬件硬件知识，对电路（主控、接口）了解； 6、EMC设计整改元器件（电容、磁珠、滤波器、电感、瞬态抑制器件等）使用掌握； 7、产品结构屏蔽设计技能掌握； 8、对EMC设计如何介入产品各个研发阶段流程掌握。 Thank you! Replace the TVS diodes to two 82pF capacitors. 3.T702T RSE issue solution Scenario 2: Replace TVS to capacitor. Changing capacitor has obvious improvement. Margin is 8dB. 3.T702T RSE issue solution SW change the HOME key operation mode from scan to GPIO. Change the TVS diode to 18pF capacitor or not. Remove D1112 and connect MKIN1 to Ground. 3.T702T RSE issue solution Scenario 3: Change HOME key Operation mode. Change HOME key operation mode has obvious improvement. With TVS diode has 8dB margin. TVS change to capacitor has 7dB margin. 3.T702T RSE issue solution Conclusion: Below three scenarios all have obvious improvement for RSE issue. Scenario 1: Cut off HOME key. Scenario 2: Replace TVS to capacitor. Scenario 3: Change HOME key Operation mode. Scenario 3 has minimum changes. So this scenario can be used for CTA samples rework. We can change the schematics and PCB layout according to these three scenarios. Change to HOME key operation mode from scan to GPIO. Add a inductor at HOME key signal in series. Decrease the HOME key footprint and move the footprint away from the main antenna keep-out area as far as possible. 3.T702T RSE issue solution This RSE issue is caused by the HOME key in main antenna area. Antenna area especially the bottom area must be keep out clearly. 4.T702T RSE