STM32 RAM调试.docVIP

STM32 RAM调试 Cpu：Stm32103vet6 64kB SRAM 分割：40KB 用于存储程序 8KB 用于存储data 1、 2、 3、 4、listing、user、C++/ASM用户界面均不用设置。 5/ 6、 6.1、 6.2、trace界面不用设置 7、 连接成功 Rebuild target USART compiling core_cm3.c... assembling startup_stm32f10x_hd.s... compiling main.c... compiling GLCD.c... compiling USART.c... compiling system_stm32f10x.c... compiling ds1302.c... compiling Systick_Delay.c... compiling misc.c... compiling stm32f10x_flash.c... compiling stm32f10x_gpio.c... compiling stm32f10x_rcc.c... compiling stm32f10x_usart.c... linking... Program Size: Code=8424 RO-data=752 RW-data=5416 ZI-data=1024 FromELF: creating hex file... .\Obj\USART.axf - 0 Error(s), 0 Warning(s). Load C:\\stm32\\shzhong\\【27】火牛板_USART1-ds1302(2014.6.14)\\Obj\\USART.AXF * JLink Info: Device STM32F103VE selected (512 KB flash, 64 KB RAM). Set JLink Project File to C:\stm32\shzhong\【27】火牛板_USART1-ds1302(2014.6.14)\JLinkSettings.ini JLink info: ------------ DLL: V4.40c, compiled Jan 24 2012 09:30:33 Firmware: J-Link ARM V8 compiled Jun 19 2012 11:29:30 Hardware: V8.00 S/N : Feature(s) : RDI,FlashDL,FlashBP,JFlash,GDBFULL * JLink Info: TotalIRLen = 9, IRPrint = 0x0011 * JLink Info: Found Cortex-M3 r1p1, Little endian. * JLink Info: TPIU fitted. * JLink Info: ETM fitted. * JLink Info: FPUnit: 6 code (BP) slots and 2 literal slots ROMTableAddr = 0xE00FF003 * JLink Info: TotalIRLen = 9, IRPrint = 0x0011 * JLink Info: Found Cortex-M3 r1p1, Little endian. * JLink Info: TPIU fitted. * JLink Info: ETM fitted. * JLink Info: FPUnit: 6 code (BP) slots and 2 literal slots * JLink Info: Found Cortex-M3 r1p1, Little endian. * JLink Info: TPIU fitted. * JLink Info: ETM fitted. * JLink Info: FPUnit: 6 code (BP) slots and 2 literal slots Target info: ------------ Device: STM32F103VE VTarget = 3.351V State of Pins: TCK: 1, TDI: 0, TDO: 1, TMS: 0, TRES: 1, TRST: 1 Hardware-Breakpoints: 6 Software-Breakpoints: 8192 Watchpoints: 4 JTAG speed: 2000 kHz Programming Done. Verify OK.