Cutting Class combination view interpret drawings-毕业论文翻译.docVIP

Cutting Class combination view interpret drawings Abstract: interpret blueprints is an important content of engineering drawing course, while the reading view of cutting class combinations is teaching difficult. This article describes how to determine the combination of the view of cutting class, how to use the line, surface projection rules, analysis view, lines, frame the meaning and spatial location, thus imagine the combination method of the shape interpret blueprints. Cutting Class combination makes the view interpret drawings easier to read. Keywords:: Cutting class combinations; view; line of surface analysis 1 Introduction Engineering Drawing is the engineering students in an existing system theory, there are important technical basis for a strong hands-on lessons. Interpret blueprints is an important part of this course, through learning, requires students to correctly and quickly read view, imagine the shape of an object. However, in practice teaching, because this course is for students in terms of a new discipline, has less to do with the high school curriculum, students are still a lack of space for imagination, so the general feeling of difficult, especially for cutting class portfolio Body view interpret blueprints, some students see the subject I do not know where to start, “2 seeking 3” Trap Line is a difficult point in teaching. Through the teaching practice, I think that end in accordance with teaching materials to explain the basics of projection, interpret drawings of the basic essentials and the basic methods, with examples focused on clarifying the line of surface analysis reading of combination steps and methods in view of the same time, pay attention to training spatial imagination of students and the idea of capacity, so that students can gradually, gradually increase the ability to interpret blueprints, no longer feel the time cutting class combination of view is difficult. 2, cutting class combination in view of charac