c1富康总结资料(国外英文资料).doc

c1富康总结资料(国外英文资料) Subject 2 operating requirements Turn around the lights in advance We are currently in the right light. We are currently in the left The clutch must be on the ground before the hand lever Step 2: turn on the left turn lamp, step on the step, hang a step, observe the rear view mirror, loosen the hand brake, slow lift off, add oil Add the gear requirement: add gear must be added, must be refuelled before adding the gear, raise the gas pedal, step off, change the gear, lift off, refueling Reduce the demand: can exceed grade to reduce gear Step 5. Step on the brake before you lose the gear, and then push the brake, move your hand, and move the accelerator Take a start, second turn, stop the oil in the corner, and look at the situation Stop: any gear can stop directly Stop: turn right lights, brake, step off, continue the brake until the vehicle stops, pull the handbrake, pull the gap, lift off, lift the brakes When the car is too slow, the clutch is slow Turn around 20 meters ahead of time to change the speed Turn left and turn the fast lane and turn right into the slow lane Turn around before you turn In the direction of the bend, the curve is sharp -- fast, slow -- slow, right turn left front corner, right rear wheel no way Step by step, step on the end, add, subtract, and stop Before turning around, avoid left, right, left, right Dont talk at the crossroads -- straight, dont talk -- turn right Subject 2: Side stop Test demands: vehicle without touch, brush pile location bar, wheel pressure not to touch the lane edge, edge location, through a into a retreat, the vehicle moving in the right location. Method of crack: 1) break right light, turn right 30 degrees, the steering wheel to adjust direction by car to the roadside pole intermediate 3, no. 1, when the wiper when the steering wheel left 45 degrees, next to the road base parallel move forward slowly, when the car and the road yellow triangle sign coincidence parking; 2) hang backward, use the clut