万用表检测电子元件经验技巧(国外英文资料).doc

万用表检测电子元件经验技巧(国外英文资料) Multimeter test common electronic component experience technique Measure the polarity of the feet of the rectifier Multimeter block set R x 1 k, black pens and any pins of the bridge pile, red pens and measured successively the remaining three legs, if the readings are infinite, the black pens and connect to the output of the bridge pile by the positive, if the reading is 4 ~ 10 k Ω, the black pens and the pin is the output of the bridge pile of the cathode, the rest of the two pins for bridge pile of ac input. Judge whether the vibration is good or bad First, use the multimeter (R x 10k block) to measure the resistance of the two ends of the crystal, if it is infinite, the crystal is not short circuit or leakage. Then test pencil inserted in the mains socket, his fingers hold any pins of crystals, will touch another pin test pencil at the top of the metal parts, if the test pencil neon bulb is red, that crystals is good; If the neon is not bright, the vibration is damaged. Single directional thyristor test Available multimeter R x 1 k or R x 100 block measurement of positive and reverse the question of arbitrary polarization resistance, if it finds a pair of very resistance to low resistance (100 Ω to lk Ω), is for the control of the black pens and receive pole, red pens and connect to the cathode, another is the anode. There are three PN knots in the thyristor, and we can measure the difference between the positive and the reverse resistance of the PN junction. Measure control (G) and cathode (C) between the resistance, if the positive and reverse resistance are zero or infinity, that control is extremely short circuit or open circuit; measure control (G) and the anode resistance between (A), positive and reverse resistance readings shall be great; When measuring the resistance between the anode (A) and the cathode (C), both positive and reverse resistance should be large. Polarity recognition of bi-directional thyristor Bidirectional thyris