低压电器的选用要求(国外英文资料).docVIP

低压电器的选用要求(国外英文资料) Electrical, low voltage One. The choice of circuit breaker 1. Usually the choice of low voltage circuit breaker (1) low voltage circuit breaker rated voltage of rated voltage not less than the line. (2) the rated current of the low-voltage circuit breaker is not smaller than the calculation of line load current. (3) the limit of low voltage circuit breaker on-off capacity not less than the largest of the short circuit current. (4) lines at the end of single phase to ground short circuit current present low voltage circuit breaker transient or short time delay tripping current setting acuity 1.25 (5) the rated current of the trip is not less than the calculation of line current. (6) undervoltage tripping device of the rated voltage is equal to the rated voltage circuit. 2. The power distribution in the choice of low voltage circuit breaker (1) the set values for the long time delay current is equal to 0. 8 to 1 times the wire carrying capacity allowed. (2) three times the set values for the long time delay current lines of return time is not less than the largest starting current of motor startup time. (3) the set values for the short time delay current not less than 1.1 (+ 1.35 KIdem Ijx). Among them, Ijx for circuit calculation of load current; K for the start current of the motor; Idem for maximum rated current. An electric motor (4) the time delay of short time delay time according to the thermal stability of the protected object check. (5) the short time delay, the instantaneous current setting value is not less than 1.1 (Ijx + K1KIdem). Among them, the K1 for motor starting current impact coefficient, preferable 1.7 ~ 2. (6) have a short time delay, the instantaneous current setting value is not less than 1.1 times the switch into the terminal to calculate short circuit current value at a lower level. 3. The choice of motor protection with low voltage circuit breaker (1) the set values for the long time delay current is equal to the rated cur