机械加工.txt(国外英文资料).doc

机械加工.txt(国外英文资料) Introduction to the A transverse size to shorten the centerless grinding machine, the centerless grinding machine is particularly suitable for use in a small installation space, and can meet the requirements of all kinds of production line to simplify and save space. Due to the grinding wheel finishing unit set in the position of grinding wheel on tilted down, so dont in the side to keep one for grinding wheels dressing of grinding wheel unit space, the space size with that of the traditional centerless grinding machine is most closely related. Thus, can greatly reduce the horizontal dimension of centerless grinder, and be able to install the grinding machine to the installation of a small space, thus, meet the requirements of all kinds of production line to simplify and save space. Edit this section principle The grinding machine of rotating surface of the workpiece with centerless grinding is usually referred to as the centerless cylindrical grinding machine. In the centerless cylindrical grinding machine (see photo), the workpiece is not centered and supported by the center, but is placed between the wheel and the wheel, supported by the board and the guide wheel. The grinding wheel is generally installed in the main shaft, the width of the circular grinding machine The wheel of the 250-mm wheel is installed in the center of the main shaft, and the wheel is the maximum width of 900 mm. The grinding wheel is spinning at high speed, the steering wheel is rotating at a slower speed, turning the workpiece into round and round. Through grinding, tiny Angle by adjusting the guide wheel axis to realize axial feed, suitable for grinding the slender cylindrical workpiece, no center hole, short shaft and set of workpiece etc. Cut grinding, through the idler pulley or the movement of the grinding wheel frame to realize the radial feed, suitable for grinding with shoulder or convex sets of artifacts, and the cone, sphere, or other element line is curve of th