机械设计基础3(国外英文资料).doc

机械设计基础3(国外英文资料) A fill-in-the-blank question (2 points, 20 points) Two members of a movement are made up of dots or lines of contact. 2. Meet the crank existence conditions of hinge four-bar linkage, take with the shortest pole adjacent pole for rack, as the crank rocker organization, take the shortest bar for frame, double crank mechanism. In CAM mechanism, the normal motion of the follower motion will have a rigid impact. In the calculation of contact strength of the straight tooth cylindrical gear, the contact stress of the nodal line is calculated and the load is borne by pairs of gears. In order to make two of the cylindrical gears properly engaged, their modulus and pressure angles must be equal. A pair of gear drives with two teeth, bending stress 6. Two rounds of hardness, and its allowable bending stresses, etc. The main failure mode of V belt transmission is the slippage and fatigue fracture. When designing V belt transmission, the v-belt model was chosen based on the calculation of the power Pc and the small wheel speed n1. The larger the pitch of the chain, the larger the parts in the chain, the greater the inhomogeneity of the chain drive. The axis at work is called the spindle. Two, the choice question (1 point, 5 minutes), choice C, B, D, B, D The root cutting of the involute standard gear occurs. C The module is larger than the hour C. The number of teeth is much higher than the number of D In the following four types of rolling bearings, they must be used in pairs. B A. Deep groove ball bearing B. Cone roller bearing C. thrust ball bearing D. Roller bearing In the following four types of couplings, the relative displacement of the two shafts can be compensated and the shock absorbent and vibration absorption can be mitigated. D A. flange coupling b. tooth coupling C. universal coupler D In the hinged four-bar mechanism, the relationship between the mechanisms driving Angle and the pressure Angle is. B A. b. b. c. d. For common bolt connections, the