机械原理要点(国外英文资料).doc

机械原理要点(国外英文资料) The position of the crankshaft mechanism with the minimum Angle of rotation is the crank and the frame twice. The component is (the unit of motion) and the part is (the unit of manufacture). In the case of an involute gear with a rack cutter, it is necessary to make the cutter (the top line of the tooth not exceed the limit of mesh) for the standard gear not to be cut. The establishment of mechanical equivalent dynamics model is the equivalent principle: the kinetic energy of equivalent components should be (equal to the total kinetic energy of the whole system). The amount of work done by the equivalent force or the instantaneous power should be equal to the force of the whole system, the amount of work done by the moment and the sum of the power produced. In the analysis of structural analysis, the structure formula of the basic rod group is (3n = 2PL). In dynamic static analysis, the static condition is (3n = 2PL). In order to guarantee the reliable continuous transmission of a pair of involute gears, the length of the actual meshing line is greater than the base circular pitch. 7. The correct involute spur gears meshing condition (two rounds of the modulus and pressure Angle is equal to) the correct meshing bevel conditions for (m, pressure Angle, helix Angle are equal) The type of the machine that produces the velocity fluctuations is the periodic velocity fluctuation, the non-periodic velocity wave which is adjusted by the flywheel and the governor. 9. There are two kinds of rigidity of rotary balance, is a kind of static balance Its weight distribution characteristic is the other is a dynamic balance in with plane its mass distribution characteristic is not in the same plane. The standard parameters of the helical gear are on the surface of the plane. The degree of freedom of the virtual component in the higher subgeneration is (-1). The high subgeneration method (plus a virtual artifact with two lower pairs) Triangle threads are mainly used f