水泵罕见弊病的七大处理方法1(国外英文资料).docVIP

水泵常见故障的七大解决方法1(国外英文资料) The seven solutions to the common failure of the pump The solution of the hot water pump Reason: the bearing is damaged; Small clearance between rolling bearing or bracket cover. Pump shaft bending or two axis of different heart; Belt is too tight; Lack of oil or oil quality; The balance on the impeller is clogged, the impeller loses balance and increases the thrust to one side. Elimination method: replace the bearing; To remove the back cover, and install a gasket between the bracket and the bearing seat. To investigate the concentricity of the pump shaft or the adjustment of the axis; Proper loosening of tape; Add in the clean butter, and butter accounts for about 60% of the space between the bearings. Remove the plug in the balance hole. No water solution Reason is that there is air in the pump body or feed line pneumatosis, or bottom valve closed lax irrigation water diversion discontent, vacuum packing serious leakage, a gate or door closed lax. Rule of elimination: water the water first, fill the pump with water, then turn on. Check whether the check valve is tight at the same time, pipe, joint presence of air leakage phenomenon, leakage is found, after removal in tapping coated with lubricating oil or mixed paint, and screw down the screws. Check the oil seal ring of pump shaft, such as wear and tear should be replaced. A leak or a leak in the line. The nut may be unscrewed when installed. If the leak is not serious, apply cement in a leaky or leaky area, or use a mixture of asphalt oil and cement. Temporary repairs may be coated with wet mud or soft soap. If a leak is in the head, a wrench can be used to tighten the nut, and if the water is leaking, it must be reassembled and replaced with cracked pipes. Lower the head of the pump and push the nozzle of the pump down to half m. Inadequate traffic This is because the driving speed is not matched or the belt is slipping, making the speed low. The axial flow pump blade installation Angle