电脑电源故障的判断(国外英文资料).docVIP

电脑电源故障的判断(国外英文资料) (1) the disconnecting fan disconnects the main power source and pulls the input and output line plug behind the power source. Then remove the plug and attachment of all parts connected to the power supply, remove the fixed screw from the power box, and remove the power box. Observe the appearance structure of the power box, remove the screw correctly and accurately, remove the outer cover. To remove the outer cover, remove the wire from the break. Remove the four screws of the stationary fan and remove the fan. According to the data, the fault caused by the power supply is about 20% ~ 30% of the total faults of the computer. The fault detection and maintenance of all parts of the main engine must also be established on the basis of normal supply. Lets discuss some common failures of the power supply. Microcomputer power generally easy to fault has the following kinds: blown fuse, power supply without losing or output voltage is not stable, the power output but no display, the boot power load ability is poor. The following is a description of the maintenance method: No output The power supply is responsible for the power supply of the computer, providing stable power supply for the CPU, memory, optical drive, etc. If there is a problem with the power supply, it will affect the normal work of the computer and even damage the hardware. Computer failure is mostly caused by power supply. I have accumulated a little experience in computer maintenance, and now I introduce you to your readers for your reference. The possible reason for this failure is that the delay time of the Reset signal that POWER GOOD entered is not enough, or POWER GOOD has no output. After turning on, use the voltmeter to measure the output of POWER GOOD (1 foot of the plug of the host), and check the delay component if no + 5V output is added. If there is a + 5V output, the delay capacitance of the delay circuit is replaced. The shaft deflection of the fan motor bearing sleeve is c