- 1、本文档共50页,可阅读全部内容。
- 2、原创力文档(book118)网站文档一经付费(服务费),不意味着购买了该文档的版权,仅供个人/单位学习、研究之用,不得用于商业用途,未经授权,严禁复制、发行、汇编、翻译或者网络传播等,侵权必究。
- 3、本站所有内容均由合作方或网友上传,本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺!文档内容仅供研究参考,付费前请自行鉴别。如您付费,意味着您自己接受本站规则且自行承担风险,本站不退款、不进行额外附加服务;查看《如何避免下载的几个坑》。如果您已付费下载过本站文档,您可以点击 这里二次下载。
- 4、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等,请点击“版权申诉”(推荐),也可以打举报电话:400-050-0827(电话支持时间:9:00-18:30)。
查看更多
高温气冷堆多头螺旋管式蒸汽发生器的设计与计算
摘 要
蒸汽发生器是高温气冷反应堆的主要设备之一。高温反应堆产生的热量被氦气冷却剂吸收,在蒸汽发生器中传递给二次回路。氦气自上而下流过发生器,水在外力作用下进入发生器并产生水蒸汽自下而上流过传热面管束。
蒸汽发生器的传热面由多头螺旋管组成。螺旋管束有很多优点:它可以充分利用换热器的空间;没有急剧的弯曲,不会增加气或水侧的压力损耗,同时也简化了工艺,减少了焊点;对受热膨胀有很好的适应性;有很高的传热系数。
在很多工业领域中,螺旋管式热交换器都得到广泛的应用,它可适用于单相流体、蒸汽以及可压缩流体的流动。螺旋管束可用于化学反应器、储藏罐和一些核反应发生器。在大规模的能源动力系统中,它还可用作太阳能集电器的接受器。
多头螺旋管式换热器在换热面结构设计、传热和压降计算方面报道的文献较少。本文从实际工程设计出发,对多头螺旋管式换热器的设计进行了研究,提出了多头螺旋管束受热面结构的设计方法,推荐了螺旋管内外的传热系数和压降的计算关系式。根据所提出设计方法和螺旋管内外的传热系数和压降的计算关系式对260MW蒸汽发生器进行了设计计算。
关键词 热交换器,传热,压降,螺旋管ABSTRACT
The steam generator is one of the important equipments in the high-temperature gas-cooled reactor. The heat generated in the high-temperature reactor and absorbed by the helium coolant is transferred the secondary circuit in steam generator. The helium flows downward through the steam generator. The water is forced into the steam generator and the resuting water/steam flow is directed upwards through the heating surface bundles.
The heating surface of the steam generator is composed of several helically wound tubes(helicoils).There are a number of obvious advantages in banks of helical tubes: they permit a very good utilization of the expensive casing volume; they do not require sharp tube bends,which increase the pressure loss on the steam/water side and which also may impose manufacturing problems or may require additional welds; and finally, they exhibit high heat transfer coefficients.
Many industries use helically and spirally coiled heat exchanger tubes for single-phase, evaporating, and condensing flows. Coils are used in chemical reactors, storage tanks, and on some nuclear stream generators. In a new application, a coiled tube has been proposed for the receiver of a concentrating-type solar collector in a large-scale power generation system.
Referenses on design of heated surface structure、calculation of heat transfer and pressure drop for heat exchanger with multi-start helical coiled tubes are less. Design method of the heat exchanger with multi-start helical coiled
您可能关注的文档
- 西医核心讲义——生理图表式.doc
- 西药学药二冲刺金题第十章:药效学.docx
- 课程结构介绍暨核心能力对应x.docx
- 语文应试2012年9月试题总汇.doc
- 设计年产350万吨1700热带连轧车间.doc
- 西宝高速公路改扩建工程土地利用和耕地保护专项报告.doc
- 课程设计报告—数控函数信号发生器.doc
- 起搏器2008指南阜外翻译版.doc
- 西药深圳市药师上岗能力测试复习题及答案.doc
- 转子动平衡的研究与设计正文.doc
- 2023学年诸暨中学高三年级第二学期3月第二次模拟考试(政治)公开课教案教学设计课件资料.docx
- 运动的合成与分解(二)公开课教案教学设计课件资料.pptx
- 近五年浙江省各地图形的翻折(轴对称)原题公开课教案教学设计课件资料.doc
- 如何做教师-2019-11-13-中关村一小相关公开课教案教学设计课件资料.pptx
- 生活中的圆周运动 (水平面)正式版公开课教案教学设计课件资料.pptx
- 专题10 条件概率与全概率公式公开课教案教学设计课件资料.docx
- 金华市东阳市2019学年第二学期期末测试卷公开课教案教学设计课件资料.doc
- 5 琥珀(第二课时)【慕课堂版】公开课教案教学设计课件资料.pptx
- 项目五 打印米老鼠模型公开课教案教学设计课件资料.ppt
- (打印版)9月25日地理周练公开课教案教学设计课件资料.docx
文档评论(0)