蓝牙耳机品质及可靠性.docVIP

Reliability and Quality Control 1.1 Reliability and Quality Control Remarks Thermal Cyclic test Test chamber consists of separate compartments; one is set at -20(C and the other set at +60(C with RH20—30% Each temperature cycle shall consist of a 1 hour exposure at -20(C followed by an hour exposure at +60(C with a 5 seconds maximum transition time between temperatures. Start cycle testing with the cold temperature and conclude with the high temperature. Test samples are power off. The test duration is for 4 cycles and must end in the hot cycle. If the sample surface has no cracks and no affect in specification, it passes the thermal cyclic test. Vibration test Check the firmware version and PSKey’s settings before test. Frequency: 30Hz Amplitude: 0.06” Time Duration: 1hr for each axis, e.g. X, Y,Z Unit Drop Test Inspect the external appearance and function before a unit is dropped (6 sides-each side 1 times) from a height listed below Drop height: 150cm to concrete floor Power off mode Mini Drop Test Inspect the external appearance and function before a unit is dropped from 4centimeters’height to wooden floor (20mm thickness). Standby mode and 6 sides each side 500 times(record every 50times) Appearance Gapping between Top cabinet and bottom cabinet between parts cannot over 0.15mm max. Gapping between Top case face and Button face and light guide face between parts cannot over 0.3mm min. Steel Ball Test The housing of unit is subjected to steel ball test with 200g steel ball of diameter 2.5cm, 50cm height and 10 times No crack and broken  ESD Test Reference Standard :IEC 801-2 Part 2 ; Sample Size: 3 sets (Temperature: 15℃~35℃, Humidity: 30~60%RH, Atmospheric Pressure: 68~106Kpa) Contact Discharge: (+/- 1KV to +/-4KV) Conductive parts which are normally touched by human body during operation, e.g. “MFB” key and “Vol” key (Metal),etc. Start from 1KV for 10 times discharge. (Every time need do the discharge for outside metal part) Ever